Create Mode

The Create Modes allow creating of components.

Before creating any components, you will need to select a namespace to create components under as well as the skin type of the new components.

Point

L-Click on the map to create a new point.

Line

L-Click on the map to start a new line and add nodes to it. Hold Ctrl to snap to angle. Shift+L-Click to create control points for Bézier curves.

Dbl-L-Click to finish the line. Note that lines must have at least two nodes.

R-Click to undo a node or control point.

Area

Generally the same as lines, with the following differences:

• The area will be automatically closed upon finishing
• Areas must have at least three nodes, or two if the second node is a Bézier curve.